New DIP geometryΒΆ
In the next dialogbox the parameters for a new DIP (Dual In Line) geometry can be entered. The DIP geometry is a device based on through holes.
The following parameters can be changed:
Nr pins
If the total amount of pins is two times the NrPins entered. The pinnumber counting starts with one, and increments with one for the following pins. The pin counting direction for the left column with pads is downwards, and for the right column with pads upwards.
Pad
Pad size solder mask
If the solder mask pad is not necessary, fill the parameter with zero.
Diameter anti power pad
The anti power pad will always be a circle.
If the anti power pad is not necessary, fill the parameter with zero.
Diameter inner pad
The inner pad will always be a circle.
If the inner pad is not necessary, fill the parameter with zero.
Drill hole
Distance
Clearance
The initial clearance is the clearance used for this geometry.
Pin 1 type
The first pin (1) can be a square or a circle. All the next pins will be circles.
The Use default rules for solder paste/mask, inner/anti power pad and clearance button can be used the fill in values based on the drill size.
